Kasco-marine Quick Disconnect/Cord Connection Manuel d'utilisateur télécharger pdf

If your Kasco Fountain, Aerator, or Circulator has a 12 gauge power cord or larger, the cord has been

shipped separate from the unit. The unit itself has a 30”+ stub cord with the male half of the Quick

Disconnect. The cord that was shipped in a separate box has the female half of the Quick Disconnect.

To assemble the cord, the Quick Disconnect must be connected. Line up the pin assembly (male end)

from the stub cord to the socket assembly (female end) on the cord and push together.

Blue Nut

or collar

Once the two ends are together, tighten the large blue nut or collar to seal the connection. The blue nut

or collar should be HAND TIGHTENED ONLY!

Small Gap

after tightening

For seasonal removal, your Quick Disconnect includes an optional water tight cover. Simply separate

the Quick Disconnect halves and insert the sealing cover into the large blue nut or collar and tighten

ﬁ rmly. The unit with the 30”+ stub cord can then be stored in a cool, dry place.

Quick Disconnect/Cord Connection

Instructions

Important - Read Carefully Before Installation

Kasco Marine, Inc.

800 Deere Rd.

Prescott, WI 54021

PH (715) 262-4488

FAX (715) 262-4487

www.kascomarine.com

#824360 Rev. 9/30/08

If your Kasco Fountain, Aerator, or Circulator has a 12 gauge power cord or larger, the cord has been shipped separate from the unit. The unit itself

Pas de commentaire

Kasco-marine Quick Disconnect/Cord Connection Manuel d'utilisateur