Kasco-marine J Series Manuel d'utilisateur télécharger pdf (Page 10)

Control Panel Installation

STEP ONE

Inspect the panel for any damage and any components

that may have loosened during shipping.

Control panel must be installed a minimum of 5ft (3m

in Canada) from the inside wall of the pond, unless

separated from the body of water by a fence wall,

or other permanent barrier that will make the unit

inaccessible to persons in the water.

Install the control panel to a post structure, side of a

building, or other reliable means. This structure must

support the panel and prevent movement/exing of the

panel. Use #10 x 1” or longer screws in the mounting

points of the control panel to secure to the post

structure. NOTE: The control panel must be hung

upright in order to be waterproof. It is also advised

to mount the panel out of direct sunlight if possible.

Mounting the panel in a North direction will prevent

heat buildup inside the panel. Also, mount the panel

above the potential ood plain to prevent water entry

during a possible ood event.

STEP TWO

Set Timer in the control panel to desired ON and OFF

times per the Instructions on the door label or the

instructions in this manual.

STEP THREE

Electrical Service wiring:

Follow all local and national electrical codes for

this installation and Consult a qualied electrician

or service person if needed.

All electrical connections to this panel must be made

with proper strain relief cord grip ttings or with

conduit connections as required by local and national

electric codes. The bottom of the enclosure is reserved

for eld installation of these connections.

3 phase: (2.3, 3.3, 5.3, 7.3)

Refer to your 3 phase control panel instructions.

Single Phase: (8400, 3.1, 5.1)

C85 / C95 non-metallic control panel:

Incoming power connection: (Power feed)

This control panel requires a 240V or 208V - 4 wire

Installation Instructions

STEP TEN

Before installing 3 phase units (2.3, 3.3, 5.3, 7.3) into

the pond, please refer to 3 phase startup procedure.

Use the ropes to position the aerator in the desired

location in the pond/lake. Anchor the ropes or secure

them to the shoreline so the ropes are free of slack, but

not tight. To prevent twisting of the unit due to torque,

you should place the anchor at least 3 feet from the

oat for each foot of depth (Ex. A 6 foot deep pond

would require an anchor 18 feet horizontally from the

oat.)

For ease of removal, you may choose to keep at least

one anchor within reach from shore, just below the

water’s surface.

STEP ELEVEN (ALTERNATE INSTALLATION)

In ponds where the water level uctuates signicantly,

you may need to suspend a small weight (12” of 1”

galvanize pipe works well) at the mid-point of the

rope to take up any slack as the water level drops. The

weight should be light enough so the aerator can rise

as the water level rises. This can also help hide ropes

by sinking them further below the surface.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Kasco-marine J Series Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement pour l'eau Kasco-marine J Series